Showing posts with label measuring. Show all posts
Showing posts with label measuring. Show all posts

Thursday, December 29, 2011

Fall Quilt Sandwiched

Measuring is a good thing. But what if your measurements are exactly what you measured and they are still off?

After going through the steps I took to get the measurements I originally used, I figured out my mistake of making the top’s side borders twice the size the book, Material Obsessions, called for. Figures. Something simple I forgot to take into consideration when piecing the back. A quick fix was to simply add a few more inches to the sides of the backing, so that is what I did. I could’ve gone a couple different routes by either finding a completely different binding or only adding the extra backing to one side, but in the end I decided I really wanted the Sandy’s Solids Walnut for the border and binding.

Once the backing was properly sized, I taped it to the kitchen floor using painters tape, smoothing and adjusting as needed. I then put the batting, Warm and Natural one-hundred percent cotton, over that repeating the process of smoothing before topping it with the quilt top. After I got it right where I wanted it, I again taped it down to keep it in place. With safety pins, I basted the quilt in the center of each block and where each of the blocks meet to keep everything in place when I begin quilting it.



There is just one problem, which is I need to embroider my name and date onto the back first. Do I date it for 2011 since that is the year I finished the piecing, or go ahead and put 2012 since that is when I’ll be finished with the actual hand quilting of the project?

Monday, December 26, 2011

The Importance of Measuring

I’m a baker and a cook and I don’t usually measure very accurately while doing so. Apparently those mad skills I possess in the kitchen do not translate into quilting.

While showing the family my quilt top I just finished for The Fall Quilt, I decided to go ahead and pull out the backing too. It looked a little small, but I figured it was just an optical illusion. However, the question quelled my mind until I made certain that was indeed the case. It wasn’t. The backing is about six inches smaller all around than I wanted it to be. Damn.

And so now I have a few options. For one, I could rip the stitches around the entire thing and add more of the inside and border fabric, but that honestly sounds like too much work. Secondly I could add more of the border fabric only and have a couple seems around the edges. Or third, use a different fabric for the binding than I had originally had in mind. I’m leaning toward the latter.